Description
Details
The XPT3 Interface Transmitter is a wall mounted controller capable of
transmitting from a
standard, single gang wall box having HOT and NEUTRAL.
Installing
the XPT3 Base Controller
Select the location for the XPT3 to be mounted.
In a standard single gang wall box, connect the Black wire from the
XPT3 to a 125 VAC hot
line and connect the White wire to Neutral.
Note:
The XPT3 does not switch any loads, it is a transmitter only.
After you have secured the transmitter to the box, set the House and
Unit codes to the
desired settings. The red House Code Wheel should be set to match the
receiver modules
that you will control in the house. The black Unit Code Wheel should be
set to the first
of a possible four sequential commands.
Orange
Wire (common -) When contacted to Blue, Brown, Gray or Yellow wire;
Contact switch held closed: one OFF signal transmitted
Contact switch released: no signal transmitted
Red
Wire (common +) When contacted to Blue, Brown, Gray or Yellow wire;
Contact switch held closed: one ON signal transmitted
Contact switch released: no signal transmitted
Note: The unit code that you set will be the Blue wire unit number
transmitted. If you
use the next three wires sequentially, (Brown, Gray, Yellow), the
commands will be the
next three sequencially above. Also, the XPT3 automatically monitors
the power line for
noise and other signal transmissions and will not transmit until the
line is clear.
X10��_Product No.: | XPT3 | ||
Whats Included: | (1) X10 PRO XPT3 |
||
Connection Requirement: | Neutral Wire | ||
Downloads: |
|