VCR Commander II also works with multiple camera systems (up to four cameras per VCR Commander). If a person starts walking around your house, as they enter Zone 1 the camera monitoring Zone 1 will turn on, and the VCR Commander II starts your VCR recording. As they enter Zone 2, the second camera will turn on (camera 1 will turn off) and the VCR will continue to record what's happening in Zone 2. As the person completes a trip around your home (ex. visiting Zones 1-4), the tape will show everything as they move between all four zones.

NEW - LEARNS MOTION SENSOR CODES! The VCR Commander II allows you to learn motion sensor codes (see control panel on right), so you can have the same motion sensor turn on a camera & turn on/record the VCR. (Solves the problem of needing double motion sensors; 1 for camera, 1 for VCR Commander)

When no motion has been detected from the motion detector for 5 minutes - the VCR Commander II will turn the VCR OFF or STOP recording. This will make sure your tape only shows the action and reduces the amount of blank, no action time.

NEW - HOME & AWAY MODE! The VCR Commander II allows you to operate in a home & away mode. In "away" mode, the VCR Commander will turn on the VCR and record the action based on being activated by a motion sensor. In "home" mode, when motion is detected - instead of turning on the VCR and recording, the VCR Commander will chime, to let you know about the action.

How it works & directions for setup The new VCR Commander learns a sequence of up to 3 different IR commands (labeled PWR, REC, PLAY, and STOP) and up to 4 different motion sensor signals. You teach the IR commands by selecting the button on the VCR Commander II (UX23A) to learn for and then using the VCR remote control to emit that command to the VCR Commander II. Learning motion sensor codes is done in a similar manner.

When the On command from the programmed X10 address is received, the VCR Commander II will issue the programmed IR sequence to the VCR through the IR emitter cable. More On commands (signals of further motion) within 5 minutes will be ignored. If no more On commands are seen within 5 minutes (no further motion), the VCR Commander II will issue the IR "Stop" command. After the "Stop" command is issued an On command will start the cycle over again.

Parts of the kit without camera: (This kit was designed for someone that already owns an XCam2 camera and transceiver module. If you do not own an XCam2 Camera yet, please see below for order options)

• VCR Commander II Base
• IR Emitter cable with 3 emitters
• Power Adapter

About the FREE Ninja Pan&Tilt Camera Mount
	Sweep&Scan 4X More Action! The robotic NINJA Pan 'n Tilt Camera Mount allows you to sweep your XCam2 video camera left, right, up and down featuring 240° views and up to four preset positions! Remotely position the camera to view whatever you want with the included ScanPad Remote. The ultimate accessory for your XCam2 Video Camera! Preset auto-pilot locations perfect for when you're not home! Gain the Power of 4 Cameras in 1 with the NINJA!	Enjoy Sweeping 240ºViews!

Return to Main Offer

About the EagleEye Motion Sensor

The EagleEye is a small, discreet wireless motion detector that allows you to control nearly any X10 camera or accessory (surveillance and home automation accessories alike) just by motion! Featuring a heat-sensitive, infrared motion sensor, the EagleEye is the easiest way to automate your home. Operates on 4 AA batteries. A Wireless Transceiver is required for operation.