Customer support -- find the help you need

Thank you for purchasing the X10 Pro 32 Piece ScanCam Kit! This kit provides all the parts you need to install entire camera systems for up to 4 customers. This system will allow your customers to switch between the cameras in their homes and view them on their TVs.

Before you begin the installation, you will need to select the locations and settings for the cameras. Typical installations might include cameras at the front and back doors and in a child's room or looking at the back yard. The cameras will each have an X10 address, consisting of the House and Unit codes. If the customer is already using X10 automation, choose a House Code that is not in use by any other modules or controllers. The cameras and their corresponding Eagle Eye motion sensors must be set to consecutive addressses within one of the following groups: 1-4, 5-8, 9-12 or 13-16. You can use up to 4 cameras in one installation.

Set the House Code on the wireless transceiver module (model TM751), plug it into an AC outlet and extend the antenna.

Set the House Code on the ScanCam remote control (model CR12A) and insert 4 AAA batteries into it. If the cameras are going to be units other than 1-4 follow the instructions in that came with the remote control to change the scan controls.

Connect the video receiver (model VR30A, found in the VK49A box) to the TV. For more detailed instructions see the manual in the box. Adjust the antenna so that it it faces in the general direction of all the cameras -- sometimes it may be best to point the antenna towards the ceiling.

Set up a camera. Set the House and Unit code on the addressable power supply (model XM10A) as you chose above (see Getting Started). Plug the power supply into a free AC outlet. Connect the camera to the power supply. The camera should come on and you should be able to get the picture on the TV. Adjust the antenna so that it points better at the antenna of the receiver. When the camera is set up, turn it off using the CR12A. Repeat these steps for each camera you are setting up.

Set up a hawkeye for each camera. Find a place for the Eagle Eye motion sensor (model MS14A) in the area where the ScanCam is installed. The Eagle Eye should be mounted about six feet off the ground. Put 2 AAA batteries in the Eagle Eye. Follow the instructions in the box to set the House and Unit code to the same address as the camera in this location. Repeat these steps for each Eagle Eye.

Once the installation is complete, you can check its operation by using the ScanRemote to switch from camera to camera while watching the picture on the TV.

Review each camera to make sure it is focused on the desired area. If it's not, adjust the focus by turning the black part of the lens

	E-mail us! If you need more help getting started, e-mail us at . Please describe in detail the problem you are experiencing.

More X10 Instructions · Product Manuals · Technical Support Center

Product	Today's Price	You Save
LAST DAY! Secure your Entire Home with the Mega 15-Piece Protector Plus Security System! Get Ironclad home security with the Security System that calls you � and Pay No Monthly Fees!	$119.99	$254.86	ORDER
LAST DAY! WideEye Robotic Deluxe Camera System! Be among the first to order this WideEye Camera System with Robotic & VCR Recording Kit - Save 66%!	$138.99	$270.94	ORDER
LAST DAY! Ultimate 4-Camera Day/Night Surveillance System! See & hear it all with 4 WideEye & Nightwatch Cameras with Motion Chime Alert & PC/Web Surveillance Kit!	$298.99	$568.88	ORDER
BREAKING NEWS! The NEW, more stylish Video Sender PLATINUM with Built-In Remote Sender is here! Send Cable, TiVo, DSS, DVDs and more to any TV in the house - no drilling, no wiring, no extra fees!	$119.90	$49.99	ORDER
X10's Wacky Weekend SALE! Don't Miss These Amazing Offers! ONE DAY LEFT!