How it works: The default setting for the remote is to control 1 group of four cameras. To set it to scan through more than four cameras, the customer has to configure the number of cameras. This is easy to do: First, slide the switch at the bottom of the remote to "Program" (See photo on left.) and hold down the button corresponding to the total number of cameras (if 6 cameras, button 6) (the LED will blink to indicate that the change is made) then slide the switch back to "Normal" while still holding down the button.  Now the scan button will work for all the cameras configured.

.Because the 4 camera groups built into the addressable power supplies (XM10A) remain unchanged, the ScanPower Director Remote Control (CR13A) sends off commands to accomplish the scanning function. This means that when changing cameras outside of one of the camera groups (group 1: Cameras 1-4; Group 2: Cameras 5-8, etc.), it will take a couple seconds for the ScanPower Director Remote Control (CR13A) to send all the necessary commands.